Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Lexus >> 2009 >> LS 460 AWD >> Repair and Diagnosis >> Accessories & Equipment >> Entertainment Systems >> Audio/Visual >> AUDIO AND VISUAL SYSTEM (w/o Multi-display) >> Radio Receiver Power Source Circuit >> Inspection Procedure

Inspection Procedure

  1. INSPECT FUSE (D MPX-B 2, P-ACC) 
    1. Disconnect the D MPX-B 2 fuse from the main body ECU.
    2. Disconnect the P-ACC fuse from the passenger side junction block.
    3. Measure the resistance of the fuses.

      Standard resistance 

      STANDARD RESISTANCE SPECIFICATION

      Tester Connection Condition Specified Condition
      D MPX-B 2 fuse Always Below 1 Ω
      P-ACC fuse Always Below 1 Ω

      NG: REPLACE FUSE 

      OK: Go to Next Step 

  2. CHECK HARNESS AND CONNECTOR (RADIO RECEIVER - BATTERY AND BODY GROUND) 
    1. Disconnect the L51 receiver connector.
    2. Measure the voltage according to the value (s) in the table below.

      Standard voltage 

      STANDARD VOLTAGE SPECIFICATION

      Tester Connection Switch Condition Specified Condition
      L51-1 (B) - Body ground Always 11 to 14 V
      L51-11 (ACC) - Body ground Engine switch on (ACC) 11 to 14 V
    3. Measure the resistance according to the value (s) in the table below.

      Standard resistance 

      STANDARD RESISTANCE SPECIFICATION

      Tester Connection Condition Specified Condition
      L51-20 (GND) - Body ground Always Below 1 Ω
      Fig 1: Identifying L51 Receiver Connector
      G04953751Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

      NG: REPAIR OR REPLACE HARNESS OR CONNECTOR 

      OK: PROCEED TO NEXT INSPECTION PROCEDURE SHOWN IN PROBLEM SYMPTOMS TABLE (See  PROBLEM SYMPTOMS TABLE   ) 

scientia non olet · About Mike's Workshop Manuals