Slip Indicator Light does not Come ON: Procedure

1. Check if a CAN communication system DTC is output. Refer to DIAGNOSIS SYSTEM .

   Result

   Result	Proceed to
   DTC is not output	A
   DTC is output	B

B → See step   5 

A: Go to next step 

1. Check if a multiplex communication system DTC is output. Refer to DTC CHECK / CLEAR .

   Result

   Result	Proceed to
   DTC is not output	A
   DTC is output	B

B → See step   6 

A: Go to next step 

1. Connect the Techstream to the DLC3.
2. Turn the engine switch on (IG).
3. Select the Active Test mode on the Techstream. Refer to DATA LIST / ACTIVE TEST .
   SLIP INDICATOR LIGHT - ACTIVE TEST
   
   

   Tester Display	Test Part	Control Range	Diagnostic Note
   Slip Indicator Light	Slip indicator light	Indicator light ON/OFF	Observe combination meter

4. Check that the slip indicator light on the combination meter turns on or off in accordance with the Techstream operation.

   OK

   The slip indicator light turns on or off in accordance with the Techstream operation.

   HINT: 

   If troubleshooting has been carried out according to Problem Symptoms Table, refer back to the table and proceed to the next step before replacing the part. Refer to PROBLEM SYMPTOMS TABLE .

NG → See step   4 

OK → See step   7 

1. Turn the engine switch off.
2. Perform the Active Test of the combination meter (meter CPU) using the Techstream. Refer to DATA LIST / ACTIVE TEST .
3. Check the combination meter.

   OK

   The slip indicator light turns on or off in accordance with the Techstream operation.

   HINT: 

   If troubleshooting has been carried out according to Problem Symptoms Table, refer back to the table and proceed to the next step. Refer to PROBLEM SYMPTOMS TABLE .

NG → See step   8 

OK → See step   7