Inspection Procedure

1. PERFORM ACTIVE TEST USING TECHSTREAM 
   1. Connect the Techstream to the DLC3.
   2. Turn the ignition switch to the ON position.
   3. Turn the Techstream on.
   4. Enter the following menus: Body Electrical / Combination Meter / Active Test.
   5. Check the CRUISE main indicator light by performing the Active Test.

   Combination Meter: 

   DIAGNOSTIC NOTE
   
   

   Tester Display	Test Part	Control Range	Diagnostic Note
   Indicat. Lamp Cruise	Cruise main indicator light	BLINK /OFF	-

   OK: Indicator light comes on/goes off. 

   NG: REPLACE COMBINATION METER 

2. READ VALUE USING TECHSTREAM 
   1. Connect the Techstream to the DLC3.
   2. Turn the ignition switch to the ON position.
   3. Turn the Techstream on.
   4. Enter the following menus: Powertrain / Cruise Control / Data List.
   5. Check the Data List for proper functioning of the CRUISE main indicator light.

CCS: 

OK: When cruise control main switch operation is performed, the result will be same as above. 

NG: REPLACE HYBRID VEHICLE CONTROL ECU 

OK: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN  PROBLEM SYMPTOMS TABLE