Inspection Procedure

HINT:

When U0073/94, U0100/65, U0114/38, U0123/62, U0124/95, U0126/63 or U0130/68 is output together with C1210/36 or C1336/98, inspect and repair the trouble areas indicated by U0073/94, U0100/65, U0114/38, U0123/62, U0124/95, U0126/63 or U0130/68 first.

1. CHECK SENSOR INSTALLATION 
   1. Check that the yaw rate and G sensor is installed properly.

   OK: The sensor is tightened to the specified torque. 

   The sensor is not tilted. 

   NG: INSTALL YAW RATE AND G SENSOR CORRECTLY  (See INSTALLATION )

   OK: Go to next step 

2. PERFORM ZERO POINT CALIBRATION OF YAW RATE AND G SENSOR 
   1. Perform the zero point calibration of the yaw rate and G sensor (See CALIBRATION ).
3. RECONFIRM DTC 
   1. Clear the DTCs (See DTC CHECK/CLEAR ).
   2. Check if the same DTCs are output (See DTC CHECK/CLEAR ).

   HINT:

   Reinstall the sensors, connectors, etc. and restore the previous vehicle conditions before rechecking for DTCs.

   Result 

   RESULT REFERENCE
   
   

   Result	Proceed to
   DTC is output.	A
   DTC is not output.	B

   B: END 

   A: REPLACE MASTER CYLINDER SOLENOID  (See DISASSEMBLY )