Blower Unit: Disassembly

REMOVE INLET CONTROL SERVO MOTOR
1. Detach the claw and remove the lever
  
  Fig 1: Identifying Claw On Lever
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Remove the 2 screws and inlet control servo motor.
  
  Fig 2: Locating Damper Servo Screws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE CLEAN AIR FILTER
1. Detach the 2 claws and remove the air filter.
  HINT:
  
  Be sure to turn the engine switch on (IG) and set the A/C to RECIRCULATION mode before removing the air filter.
  
  Fig 3: Identifying Air Filter Claws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
REMOVE COOLING UNIT WITH FAN MOTOR SUB-ASSEMBLY
1. Remove the 3 screws and fan motor
  
  Fig 4: Locating Fan Motor Screws
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002