Inspection Procedure

HINT.

Read freeze frame data using the Techstream The ECM records vehicle and driving condition information as freeze frame data the moment a DTC is stored When troubleshooting, freeze frame data can be helpful in determining whether the vehicle was running or stopped, whether the engine was warmed up or not, whether the air fuel ratio was lean or rich, as well as other data recorded at the time of a malfunction

1. CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P2119) 
   1. Connect the Techstream to the DLC3
   2. Turn the engine switch on (IG).
   3. Turn the Techstream ON
   4. Enter the following menus Powertrain / Engine / Trouble Codes
   5. Read the DTCs

      Result 

      RESULT CHART
      
      

      Result	Proceed to
      DTC P2119 is output	A
      DTC P2119 and other DTCs are output	B

      HINT.

      If any DTCs other than P2119 are output, troubleshoot those DTCs first.

   B: GO TO DTC CHART  (See DIAGNOSTIC TROUBLE CODE CHART )

   A: Go to next step 

2. CHECK WHETHER DTC OUTPUT RECURS (DTC P2119) 
   1. Connect the Techstream to the DLC3
   2. Turn the engine switch on (IG)
   3. Turn the Techstream ON.
   4. Clear DTCs (See DTC CHECK/CLEAR )
   5. Start the engine and allow the engine to idle for 15 seconds.
   6. Fully depress and release the accelerator pedal quickly (to fully open and close the throttle valve).
   7. Enter the following menus- Powertrain / Engine / Trouble Codes
   8. Read the DTCs

      HINT

      The output voltage of the throttle position sensor can be checked using the Techstream. Variations in the output voltage indicate that the throttle actuator is in operation. To check the output voltage using the Techstream, enter the following menus: Powertrain / Engine / Data List / Throttle Position No 1.

      OK: No DTC output. 

   NG: REPLACE THROTTLE BODY ASSEMBLY  (See REMOVAL )

   OK: END