Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Lexus >> 2008 >> IS 250 AWD >> Repair and Diagnosis >> Heating, Ventilation & A/C (HVAC) >> HVAC Control Systems >> Air Conditioning >> Room Temperature Sensor >> Removal

Room Temperature Sensor: Removal

  1. DISCONNECT CABLE FROM NEGATIVE BATTERY 
    CAUTION: Wait for 90 seconds after disconnecting the cable to prevent airbag deployment. (See PRECAUTION )
  2. REMOVE FRONT DOOR SCUFF PLATE LH (w/o Illumination)  (See REMOVAL )
  3. REMOVE FRONT DOOR SCUFF PLATE LH (w/ Illumination)  (See REMOVAL )
  4. REMOVE FRONT DOOR OPENING TRIM COVER LH  (See REMOVAL )
  5. REMOVE SIDE INSTRUMENT PANEL LH  (See REMOVAL )
  6. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY  (See REMOVAL )
  7. REMOVE LOWER INSTRUMENT PANEL FINISH PANEL SUB-ASSEMBLY  (See REMOVAL )
  8. REMOVE DRIVER SIDE KNEE AIRBAG ASSEMBLY  (See REMOVAL )
  9. REMOVE ROOM TEMPERATURE SENSOR 
    1. Disconnect the connector and air hose.
    2. Detach the claw and remove the sensor.
      Fig 1: Locating Connector Air Hose
      G05831617Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About Mike's Workshop Manuals