Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Lexus >> 2008 >> GS 460 >> Repair and Diagnosis >> External Pages >> Different car >> Section 14 (Engine Control System - System And Circuit Testing, On-Vehicle Inspection, Removal, Inspection & Installation) >> Integration Relay >> Removal

Integration Relay: Removal

WARNING: This page is about a different car, the 2008 Lexus GS 350. However, it is still accessible from the selected car via links, so may be relevant.
  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
  2. REMOVE COOL AIR INTAKE DUCT SEAL  (See REMOVAL )
  3. REMOVE ENGINE ROOM SIDE COVER LH  (See REMOVAL )
  4. REMOVE INTEGRATION RELAY 
    1. Remove the engine room No. 1 relay block cover.
    2. Using a screwdriver, detach the 2 claws and disconnect the integration relay from the engine room No. 2 relay block.
    3. Disconnect the 3 connectors.
scientia non olet · About Mike's Workshop Manuals