On-Vehicle Inspection

INSPECT CAMSHAFT TIMING OIL CONTROL VALVE ASSEMBLY

Connect the Techstream to the DLC3.
1. Turn the power switch ON (IG).
2. Turn the Techstream main switch ON.
3. Set the vehicle to the "INSPECTION MODE" (see INSPECTION MODE PROCEDURE ).
Start and warm up the engine.
Idle the engine.
Select the following menus: Powertrain / Engine / Active Test / Control the VVT Linear (Bank 1) or Control the VVT Linear (Bank 2) or Control the VVT System (Bank 1) or Control the VVT System (Bank 2) or Control the VVT Exhaust Linear (Bank 1) or Control the VVT Exhaust Linear (Bank 2).

Specified condition

TESTER OPERATION AND SPECIFIED CONDITION

Tester Operation	Specified Condition
OCV OFF	Normal engine speed
OCV ON	Engine Idles roughly or stalls soon after OCV is switched from OFF to ON

If the result is not as specified, check the oil control valve and wirings.

HINT:

Control the VVT Linear (Bank 1): Command to activate exhaust and intake side oil control valves of bank 1 (Control range: Between -128 to 127%).
Control the VVT Linear (Bank 2): Command to activate exhaust and intake side oil control valves of bank 2 (Control range: Between -128 to 127%).
Control the VVT System (Bank 1): Command to activate oil control valve of bank 1 (Control range: ON/OFF).
Control the VVT System (Bank 2): Command to activate oil control valve of bank 2 (Control range: ON/OFF).
Control the VVT Exhaust Linear (Bank 1): Command to activate exhaust side oil control valve of bank 1 (Control range: Between -128 to 127%).
Control the VVT Exhaust Linear (Bank 2): Command to activate exhaust side oil control valve of bank 2 (Control range: Between -128 to 127%).