Inspection Procedure

1. Disconnect the z17 display connector.
2. Disconnect the z16 receiver connector.
3. Measure the resistance of the wire harness side connectors.

   Standard resistance 

   RESISTANCE SPECIFICATION
   
   

   Tester Connection	Specified Condition
   z17-4 (VV-) - z16-2 (GND)	Below 1 Ω
   z-17-1 (VV+) - Z16-1 (NTSC)	Below 1 Ω
   z17-4 (VV-) - Body ground	10 kΩ or higher
   z17-1 (VV+) - Body ground	10 kΩ or higher
   z16-3 (SLD) - Body ground	10 kΩ or higher

Fig 1: Identifying Z17 Display And Z16 Receiver Connector Terminals
Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

NG: REPAIR OR REPLACE HARNESS OR CONNECTOR 

OK: PROCEED TO NEXT INSPECTION PROCEDURE SHOWN IN  PROBLEM SYMPTOMS TABLE