Inspection Procedure

1. Check for DTC (see DTC CHECK/CLEAR  ).

   OK: 

   DTC is not output. 

NG : CHECK FLOWCHART OF EACH DTC  (See DATA LIST/ACTIVE TEST  )

OK : Go to Next Step 

1. Disconnect the A49 front active stabilizer control ECU connector.
2. Measure the resistance according to the value (s) in the table below.

   Standard resistance 

   STANDARD RESISTANCE REFERENCE
   
   

   Tester Connection	Switch Condition	Specified Condition
   A49-1 (LCN+) - A49-8 (LCN-)	Engine switch off	54 to 69 Ω
   A49-2 (CANH) - A49-3 (CANL)	Engine switch off

NG : REPAIR OR REPLACE HARNESS OR CONNECTOR 

Fig 1: Identifying A49 Front Active Stabilizer Control ECU Connector Terminal

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

OK : Go to Next Step 

1. Turn the engine switch off.
2. Exchange the front active stabilizer control ECU with the rear active stabilizer control ECU.
3. Connect Techstream to the DLC3.
4. Turn the engine switch on (IG) and press the Techstream main switch ON.
5. Clear the DTC (see DTC CHECK/CLEAR  ).
6. Check for DTC.

   Result 

   DTC RESULT REFERENCE
   
   

   Result	Proceed to
   DTC C1917 is output	A
   DTC is not output	B

B : CHECK INTERMITTENT PROBLEMS 

A : REPLACE FRONT ACTIVE STABILIZER CONTROL ECU  (See REMOVAL  )