Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Lexus >> 2008 >> GS 350 AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 13 (Engine Control System (1UR-FSE) - Circuit Tests And Repair Information) >> VVT Sensor >> Removal

VVT Sensor: Removal

WARNING: This page is about a different car, the 2008 Lexus GS 460. However, it is still accessible from the selected car via links, so may be relevant.
  1. REMOVE COOL AIR INTAKE DUCT SEAL  (See REMOVAL )
  2. REMOVE ENGINE ROOM SIDE COVER LH  (See REMOVAL )
  3. REMOVE ENGINE ROOM SIDE COVER RH  (See REMOVAL )
  4. REMOVE V-BANK COVER SUB-ASSEMBLY  (See REMOVAL )
  5. REMOVE NO. 1 AIR CLEANER INLET  (See REMOVAL )
  6. REMOVE AIR CLEANER CAP SUB-ASSEMBLY  (See REMOVAL )
  7. REMOVE VVT SENSOR 
    1. Disconnect the 4 VVT sensors.
    2. Remove the 4 bolts and 4 VVT sensors.
      Fig 1: Locating Bolts And VVT Sensors
      G05804100Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About Mike's Workshop Manuals