Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Lexus >> 2008 >> GS 350 AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 13 (Engine Control System (1UR-FSE) - Circuit Tests And Repair Information) >> VVT Sensor >> Installation

VVT Sensor: Installation

WARNING: This page is about a different car, the 2008 Lexus GS 460. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL VVT SENSOR 
    1. Install the 4 VVT sensors with the 4 bolts.

      Torque: 10 N*m (102 kgf*cm, 7 ft.*lbf) 

    2. Connect the 4 VVT sensor connectors.
  2. INSTALL AIR CLEANER CAP SUB-ASSEMBLY  (See INSTALLATION )
  3. INSTALL NO. 1 AIR CLEANER INLET  (See INSTALLATION )
    Fig 1: Locating Bolts And VVT Sensors
    G05804100Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  4. INSTALL V-BANK COVER SUB-ASSEMBLY  (See INSTALLATION )
  5. INSTALL ENGINE ROOM SIDE COVER RH  (See INSTALLATION )
  6. INSTALL ENGINE ROOM SIDE COVER LH  (See INSTALLATION )
  7. INSTALL COOL AIR INTAKE DUCT SEAL  (See INSTALLATION )
  8. INSPECT FOR OIL LEAK 
scientia non olet · About Mike's Workshop Manuals