Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Lexus >> 2008 >> GS 350 AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 13 (Engine Control System (1UR-FSE) - Circuit Tests And Repair Information) >> Engine Coolant Temperature Sensor >> Installation

Engine Coolant Temperature Sensor: Installation

WARNING: This page is about a different car, the 2008 Lexus GS 460. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL ENGINE COOLANT TEMPERATURE SENSOR 
    1. Install a new gasket to the engine coolant temperature sensor.
    2. Install the engine coolant temperature sensor.

      Torque: 21 N*m (214 kgf*cm, 15 ft.*lbf) 

    3. Connect the engine coolant temperature sensor connector.
      Fig 1: Locating Engine Coolant Temperature Sensor Connector
      G05804107Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. ADD ENGINE COOLANT  (See REPLACEMENT )
  3. INSPECT FOR COOLANT LEAK  (See ON-VEHICLE INSPECTION )
  4. INSTALL V-BANK COVER SUB-ASSEMBLY  (See INSTALLATION )
  5. INSTALL ENGINE UNDER COVER 
scientia non olet · About Mike's Workshop Manuals