Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Lexus >> 2007 >> RX 400h AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 697 (Cruise Control System (Service Information)) >> Cruise Control Main Switch >> Removal >> Removal

Cruise Control Main Switch: Removal: Removal

WARNING: This page is about a different car, the 2010 Toyota 4Runner. However, it is still accessible from the selected car via links, so may be relevant.
  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    WARNING:

    Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to disable the SRS system.

    NOTE:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected. Refer to INITIALIZATION .

  2. REMOVE LOWER NO. 3 STEERING WHEEL COVER  . Refer to REMOVAL - Step 2
  3. REMOVE LOWER NO. 2 STEERING WHEEL COVER  . Refer to REMOVAL - Step 3
  4. REMOVE STEERING PAD  . Refer to REMOVAL - Step 4
  5. REMOVE CRUISE CONTROL MAIN SWITCH 
    1. Disconnect the connector.
      Fig 1: Locating Cruise Control Main Switch
      GTY213897Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Remove the 2 screws and switch.
      Fig 2: Locating Screws And Switch
      GTY223873Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About Mike's Workshop Manuals