Yaw Rate And Acceleration Sensor: Installation: Installation

WARNING: This page is about a different car, the 2009 Lexus IS F. However, it is still accessible from the selected car via links, so may be relevant.

INSTALL YAW RATE AND ACCELERATION SENSOR
1. Connect the yaw rate and acceleration sensor connector.
  
  Fig 1: Locating Yaw Rate And Acceleration Sensor Connector
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Install the yaw rate and acceleration sensor with the 2 bolts.
  
  Fig 2: Locating Bolts And Yaw Rate And Acceleration Sensor
  Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  
  Torque: 15 N*m (153 kgf*cm, 11 ft.*lbf)
  NOTE:
  - Do not damage the yaw rate and acceleration sensor.
  - Make sure that the yaw rate and acceleration sensor is installed securely.
3. Install the 2 wire harness clamps.
INSTALL NO. 2 CONSOLE BOX DUCT . Refer to INSTALLATION - Step 6
INSTALL CONSOLE BOX . Refer to INSTALLATION - Step 1
INSTALL CONSOLE BOX REGISTER ASSEMBLY . Refer to INSTALLATION - Step 2
INSTALL REAR ASH RECEPTACLE ASSEMBLY . Refer to INSTALLATION - Step 41
INSTALL FRONT ASH RECEPTACLE ASSEMBLY . Refer to INSTALLATION - Step 41
INSTALL CONSOLE PANEL SUB-ASSEMBLY . Refer to INSTALLATION - Step 42
INSTALL UPPER NO. 2 CONSOLE PANEL GARNISH . Refer to INSTALLATION - Step 43
INSTALL UPPER NO. 1 CONSOLE PANEL GARNISH . Refer to INSTALLATION - Step 44
INSTALL SHIFT LEVER KNOB SUB-ASSEMBLY . Refer to INSTALLATION - Step 45
CONNECT CABLE TO NEGATIVE BATTERY TERMINAL
PERFORM YAW RATE AND ACCELERATION SENSOR ZERO POINT CALIBRATION
HINT:

Refer to CALIBRATION .
CHECK FOR SENSOR SIGNAL
HINT:

Refer to TEST MODE PROCEDURE .