Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Lexus >> 2007 >> RX 400h AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 191 (Engine Control System (2UZ-FE)) >> Engine Coolant Temperature Sensor >> Removal

Engine Coolant Temperature Sensor: Removal

WARNING: This page is about a different car, the 2007 Toyota Land Cruiser. However, it is still accessible from the selected car via links, so may be relevant.
  1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
    CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
  2. DRAIN ENGINE COOLANT (See  REPLACEMENT  ) 
  3. REMOVE V-BANK COVER SUB-ASSEMBLY (see  REMOVAL  ) 
  4. REMOVE INTAKE AIR CONNECTOR PIPE (see  REMOVAL  ) 
  5. REMOVE THROTTLE BODY (see  REMOVAL  ) 
  6. REMOVE ENGINE COOLANT TEMPERATURE SENSOR 
    1. Disconnect the sensor connector.
    2. Remove the sensor.
    3. Remove the gasket from the sensor.
    Fig 1: Locating Gasket And Sensor
    G05196922Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About Mike's Workshop Manuals