Inspection Procedure

HINT:

Read freeze frame data using the intelligent tester. The ECM (Included in HV control ECU) records vehicle and driving condition information as freeze frame data the moment a DTC is stored. When troubleshooting, freeze frame data can help determine if the vehicle was moving or stationary, if the engine was warmed up or not, if the air-fuel ratio was lean or rich, and other data, from the time the malfunction occurred.

CHECK ANY OTHER DTCS OUTPUT (IN ADDITION TO DTC P2111 or P2112)

Connect the intelligent tester to the DLC3.
Turn the ignition switch to the ON position.
Turn the tester ON.
Enter the following menus: DIAGNOSIS / ENHANCED OBD II / DTC INFO / CURRENT CODES.

Read the DTCs.

Result

RESULT REFERENCE

Display (DTC Output)	Proceed to
P2111 or P2112	A
P2111 or P2112 and other DTCs	B

HINT:

If any DTCs other than P2111 or P2112 are output, troubleshoot those DTCs first.

B: GO TO DTC CHART

A: Go to next step

INSPECT THROTTLE BODY ASSEMBLY (VISUALLY CHECK THROTTLE VALVE)
1. Check for contamination between the throttle valve and the housing. If necessary, clean the throttle body. And check that the throttle valve moves smoothly.
  OK: Throttle valve is not contaminated with foreign objects and moves smoothly.
NG: REPLACE THROTTLE BODY ASSEMBLY

OK: Go to next step

CHECK WHETHER DTC OUTPUT RECURS (DTC P2111 OR P2112)

Connect the intelligent tester to the DLC3.
Put the engine in inspection mode (See INSPECTION MODE PROCEDURE ).
Turn the tester ON.
Clear the DTCs (See DTC CHECK / CLEAR ).
Start the engine, and fully depress and release the accelerator pedal quickly (to fully open and close the throttle valve).
Enter the following menus: DIAGNOSIS / ENHANCED OBD II / DTC INFO / CURRENT CODES

Read the DTCs.

Result

RESULT REFERENCE

Display (DTC Output)	Proceed to
No DTC	A
P2111 or P2112	B

B: REPLACE HV CONTROL ECU

A: CHECK FOR INTERMITTENT PROBLEMS