Inspection Procedure

READ VALUE OF DATA LIST (TPS 1 SW SIGNAL)

Fig 1: Checking Value Of Data List (TPS 1 SW Signal)

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Connect terminals TPS1 and E1 of the E5 and E6 TCM connector.
HINT:

Before checking, do visual and contact pressure checks on the TCM connector.
Connect the intelligent tester or Techstream to the DLC3.
Turn the engine switch on (IG) and push the tester main switch ON.
Enter the following menus:
1. Intelligent tester - Select: DIAGNOSIS / OBD/MOBD / ECT / DATA LIST.
2. Techstream - Select: Powertrain / ECT / Data List.

Read the value displayed on the tester.

Result

Intelligent tester

RESULT CHART

Tester Display	Proceed to
TPS 1 SW OFF	A
TPS 1 SW ON	B

Techstream

TESTER DISPLAY REFERENCE

Tester Display	Proceed to
TPS 1 Switch OFF	A
TPS 1 Switch ON	B

B: Go to step 3

A: GO TO NEXT STEP

REPLACE TCM
1. Replace the TCM (see REMOVAL ).
NEXT

PERFORM AT REGISTRATION (See REGISTRATION )

CHECK HARNESS AND CONNECTOR (TRANSMISSION WIRE - TCM)

Fig 2: Checking Harness And Connector (Transmission Wire - TCM)

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

Measure the resistance of the wire harness side connectors.

Standard resistance

TESTER CONNECTION SPECIFIED CONDITION CHART

Tester Connection	Condition	Specified Condition
E50-17 (TPS1) - E6-25 (TPS1)	Always	Below 1 Ω
E50-17(TPS1)or E6-25 (TPS1) - Body ground	Always	10 kΩ or higher

NG: REPAIR OR REPLACE HARNESS OR CONNECTOR

OK: GO TO NEXT STEP

INSPECT TRANSMISSION WIRE (OIL PRESSURE SWITCH)

Fig 3: Checking Transmission Wire (Oil Pressure Switch)

Measure the resistance of the transmission wire.

Standard resistance

TESTER CONNECTION SPECIFIED CONDITION CHART

Tester Connection	Condition	Specified Condition
Oil pressure switch connector-17 (TPS1)	Always	Below 1 Ω
Oil pressure switch connector or 17 (TPS1) - Body ground	Always	10 kΩ or higher

NG: REPAIR OR REPLACE TRANSMISSION WIRE (See REMOVAL )

OK: REPLACE OIL PRESSURE SWITCH (See DISASSEMBLY )