Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Lexus >> 2007 >> LS 460L >> Repair and Diagnosis >> External Pages >> Different car >> Section 739 (Engine Control System - DTCS P1217 Through P2A03) >> DTC P1564 ASCD Steering Switch >> DTC Confirmation Procedure

DTC Confirmation Procedure

WARNING: This page is about a different car, the 2007 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: If DTC Confirmation Procedure has been previously conducted, always turn ignition switch OFF and wait at least 10 seconds before conducting the next test.

WITH CONSULT-II 

  1. Turn ignition switch ON.
  2. Select "DATA MONITOR" mode with CONSULT-II.
  3. Wait at least 10 seconds.
  4. Press MAIN switch for at least 10 seconds, then release it and wait at least 10 seconds.
  5. Press CANCEL switch for at least 10 seconds, then release it and wait at least 10 seconds.
  6. Press RESUME/ACCELERATE switch for at least 10 seconds, then release it and wait at least 10 seconds.
  7. Press SET/COAST switch for at least 10 seconds, then release it and wait at least 10 seconds.
  8. If DTC is detected, go to "DIAGNOSTIC PROCEDURE ."

WITH GST 

Follow the procedure "WITH CONSULT-II" above.

scientia non olet · About Mike's Workshop Manuals