Inspection Procedure

WARNING: This page is about a different car, the 2007 Nissan Maxima. However, it is still accessible from the selected car via links, so may be relevant.

SELF-DIAGNOSIS RESULT CHECK
Check self-diagnosis results.

Self-diagnosis results

BATTERY VOLTAGE

Is the above displayed in the self-diagnosis item?

YES: GO TO 2.

NO: Inspection End.
CONNECTOR INSPECTION
1. Turn the ignition switch OFF and disconnect the ABS actuator and electric unit (control unit) connector E125.
2. Check the terminals for deformation, disconnection, looseness or damage.
OK or NG

OK: GO TO 3.

NG: Repair or replace as necessary.

ABS/TCS CONTROL UNIT POWER AND GROUND CIRCUIT INSPECTION

Measure the voltage and continuity between the ABS actuator and electric unit (control unit) connector E125 and ground.

ABS ACTUATOR AND ELECTRIC UNIT SPECIFICATION

Signal name	ABS actuator and electric unit (control unit) connector E125	Ground	Measured value
Power supply	16	-	Battery voltage (Approx. 12V)
Ground	3		Continuity should exist.
Ground	4		Continuity should exist.

OK or NG

OK: Check the battery for loose terminals, low voltage, etc. Repair as necessary.

NG: Repair the circuit.