Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Lexus >> 2007 >> IS 250 AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 16 (Engine Control System (2GR-FSE) - System And Circuit Testing, On-Vehicle Inspection, Removal, Inspection And Installation) >> Integration Relay >> Removal

Integration Relay: Removal

WARNING: This page is about a different car, the 2007 Lexus IS 350. However, it is still accessible from the selected car via links, so may be relevant.
  1. REMOVE COOL AIR INTAKE DUCT SEAL (See  REMOVAL  ) 
  2. REMOVE ENGINE ROOM SIDE COVER LH (See  REMOVAL  ) 
  3. REMOVE INTEGRATION RELAY 
    1. Remove the No. 2 relay block cover.
    2. Using a screwdriver, detach the 2 claws and disconnect the integration relay from the engine room No. 2 relay block.

      HINT:

      Tape the screwdriver tip before use.

    3. Disconnect the 3 connectors.
      Fig 1: Identifying Integration Relay From Engine Room Junction Block
      G05285396Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
scientia non olet · About Mike's Workshop Manuals