Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Lexus >> 2007 >> IS 250 AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 16 (Engine Control System (2GR-FSE) - System And Circuit Testing, On-Vehicle Inspection, Removal, Inspection And Installation) >> Engine Coolant Temperature Sensor >> Removal

Engine Coolant Temperature Sensor: Removal

WARNING: This page is about a different car, the 2007 Lexus IS 350. However, it is still accessible from the selected car via links, so may be relevant.
  1. REMOVE COOL AIR INTAKE DUCT SEAL (See  REMOVAL  ) 
  2. REMOVE ENGINE ROOM SIDE COVER LH (See  REMOVAL  ) 
  3. REMOVE ENGINE ROOM SIDE COVER RH (See  REMOVAL  ) 
  4. REMOVE V-BANK COVER SUB-ASSEMBLY (See  REMOVAL  ) 
  5. REMOVE FRONT FENDER PROTECTOR UPPER LH (See  REMOVAL  ) 
  6. REMOVE FRONT FENDER PROTECTOR UPPER RH (See  REMOVAL  ) 
  7. REMOVE ROOF DRIP SIDE FINISH MOLDING LH (See  REMOVAL  ) 
  8. REMOVE ROOF DRIP SIDE FINISH MOLDING RH (See  REMOVAL  ) 
  9. REMOVE FRONT WIPER ARM HEAD CAP (See  REMOVAL  ) 
  10. REMOVE WINDSHIELD WIPER ARM AND BLADE ASSEMBLY LH (See  REMOVAL  ) 
  11. REMOVE WINDSHIELD WIPER ARM AND BLADE ASSEMBLY RH (See  REMOVAL  ) 
  12. REMOVE COWL TOP VENTILATOR LOUVER SUB-ASSEMBLY (See  REMOVAL  ) 
  13. DISCHARGE FUEL SYSTEM PRESSURE (See  REMOVAL  ) 
  14. DRAIN ENGINE COOLANT (See  COOLANT  ) 
  15. DISCONNECT NO. 2 VENTILATION HOSE (See  REMOVAL   ) 
  16. REMOVE AIR CLEANER CAP WITH AIR CLEANER HOSE (See  REMOVAL   ) 
  17. REMOVE THROTTLE BODY (See  REMOVAL   ) 
  18. REMOVE INTAKE AIR SURGE TANK ASSEMBLY (See  REMOVAL  ) 
  19. REMOVE INTAKE MANIFOLD (See  REMOVAL  ) 
  20. REMOVE ENGINE COOLANT TEMPERATURE SENSOR 
    1. Disconnect the engine coolant temperature sensor connector.
    2. Remove the engine coolant temperature sensor.
    3. Remove the gasket from the engine coolant temperature sensor.
scientia non olet · About Mike's Workshop Manuals