Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Lexus >> 2007 >> IS 250 AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 16 (Engine Control System (2GR-FSE) - System And Circuit Testing, On-Vehicle Inspection, Removal, Inspection And Installation) >> Engine Coolant Temperature Sensor >> Inspection

Engine Coolant Temperature Sensor: Inspection

WARNING: This page is about a different car, the 2007 Lexus IS 350. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSPECT ENGINE COOLANT TEMPERATURE SENSOR 
    1. Partially soak the sensor in the water and warm up the water.
      Fig 1: Identifying Engine Coolant Temperature Sensor
      G05285367Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
      Fig 2: Identifying Engine Coolant Temperature Sensor Chart
      G05316240Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
    2. Measure the resistance between the terminals.

      Standard resistance 

      RESISTANCE SPECIFIED CONDITION

      Condition Specified Condition
      Approx. 20°C (68°F) 2.32 to 2.59 kΩ
      Approx. 80°C (176°F) 0.310 to 0.326 kΩ

      If the result is not as specified, replace the sensor.

      NOTE: When checking the sensor in the water, keep the terminals dry. After the check, wipe the sensor dry.
scientia non olet · About Mike's Workshop Manuals