Inspection Procedure

NOTE: When the seat belt control ECU is replaced with a new one, Active Test must be performed. (See INITIALIZATION )

CHECK DTC OUTPUT (DYNAMIC RADAR CRUISE CONTROL SYSTEM)
1. Delete the DTC (See DTC CHECK / CLEAR ).
2. Check for DTCs.
  OK: DTC P1617 is not output.
NG: GO TO DYNAMIC RADAR CRUISE CONTROL SYSTEM (See DIAGNOSTIC TROUBLE CODE CHART )

OK: Go to next step.
CHECK DTC OUTPUT (PRE-COLLISION SYSTEM)
1. Delete the DTC (See DTC CHECK / CLEAR ).
2. Recheck for DTCs.
  OK: DTC B2065 is not output.
NG: REPLACE SEAT BELT CONTROL ECU (See SEAT BELT CONTROL ECU )

OK: USE SIMULATION METHOD TO CHECK