How To Proceed With Troubleshooting

HINT:

• Use the following procedures to troubleshoot the air conditioning system.
• *: Use the intelligent tester.

1. VEHICLE BROUGHT TO WORKSHOP 
2. INSPECT BATTERY VOLTAGE 
   1. Inspect the battery voltage.

      Standard voltage: 11 to 14 V 

      If the voltage is below 11 V, recharge or replace the battery before proceeding.

3. CHECK COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM* 
   1. Use the intelligent tester to check if the CAN Communication System is functioning normally.

      Result 

      COMMUNICATION FUNCTION OF CAN COMMUNICATION SYSTEM
      
      

      Result	Proceed to
      CAN DTC is not output	A
      CAN DTC Is output	B

   B: Go to  CAN COMMUNICATION 

   A: Go to Next Step 

4. CHECK FOR DTC* 
   1. Check for DTCs and note any codes that are output.
   2. Delete the DTCs.
   3. Recheck for DTCs. Based on the DTCs output above, try to force output of the A/C system DTC by simulating the operation indicated by the DTC.

      Result 

      DTC RESULT CHART
      
      

      Result	Proceed to
      DTC is not output	A
      DTC is output	B

   B: Go to step  7

   A: Go to Next Step 

5. PROBLEM SYMPTOMS TABLE 
   1. Refer to the PROBLEM SYMPTOMS TABLE  .

      Result 

      RESULT CHART
      
      

      Result	Proceed to
      Fault is not listed in problem symptoms table	A
      Fault is listed in problem symptoms table	B

   B: Go to step  7

   A: Go to Next Step 

6. OVERALL ANALYSIS AND TROUBLESHOOTING* 
   1. See ACTUATOR CHECK 
   2. See DATA LIST / ACTIVE TEST 
   3. See TERMINALS OF ECU 
   4. On-vehicle Inspection
   5. Inspection
7. ADJUST, REPAIR OR REPLACE 

   NEXT: END