Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Lexus >> 2007 >> ES 350 >> Repair and Diagnosis >> Accessories & Equipment >> Entertainment Systems >> Audio/Visual >> Audio And Visual System >> Sound Signal Circuit between Radio Receiver and Stereo Component Amplifier >> Inspection Procedure

Inspection Procedure

  1. CHECK HARNESS AND CONNECTOR (RADIO RECEIVER - STEREO COMPONENT AMPLIFIER) 
    1. Disconnect the connectors from the radio receiver and stereo component amplifier.
    2. Measure the resistance according to the value(s) in the table below.

      Standard resistance 

      RESISTANCE SPECIFICATION

      Tester Connection Condition Specified Condition
      L+ - L+ Always Below 1 Ω
      L- - L- Always Below 1 Ω
      R+ - R+ Always Below 1 Ω
      R- - R- Always Below 1 Ω
      SLD - SLD Always Below 1 Ω
      L+ - Body ground Always 10 kΩ or higher
      L- - Body ground Always 10 kΩ or higher
      R+ - Body ground Always 10 kΩ or higher
      R- - Body ground Always 10 kΩ or higher
      SLD - Body ground Always 10 kΩ or higher
    Fig 1: Identifying Radio Receiver And Stereo Component Amplifier Connector Terminals
    G05252975Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

    NG: REPAIR OR REPLACE HARNESS OR CONNECTOR 

    OK: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE 

scientia non olet · About Mike's Workshop Manuals