Inspection Procedure

HINT:

Read freeze frame data using the intelligent tester or the OBD II scan tool. The ECM records vehicle and driving condition information as freeze frame data the moment a DTC is stored. When troubleshooting, freeze frame data can help determine if the vehicle was running or stopped, if the engine was warmed up or not, if the air-fuel ratio was lean or rich, and other data from the time the malfunction occurred.

1. CHECK OTHER DTC OUTPUT (IN ADDITION TO DTC P2119) 

   Result 

   OTHER DTC OUTPUT (IN ADDITION TO DTC P2119)
   
   

   Display (DTC Output)	Proceed to
   Only P2119 is output	A
   P2119 and other codes are output	B

   B : GO TO RELEVANT  DIAGNOSTIC TROUBLE CODE CHART  

   A : Go to next step 

2. CHECK IF DTC OUTPUT RECURS (DTC P2119) 
   1. Clear the DTC (See DTC CHECK / CLEAR  ).
   2. Allow the engine to idle for 15 seconds.
   3. Pull the hand brake and shift the gear to D.
   4. Depress the brake pedal securely and the accelerator pedal fully for 5 seconds.
   5. Read the DTC.

   HINT:

   Actual throttle position (TP) sensor voltage can be confirmed using the intelligent tester [DATA LIST/ALL/THROTTLE POS #1].

   OK : 

   No DTC output. 

   NG : REPLACE THROTTLE BODY ASSEMBLY 

   OK : NORMAL