Engine Control System (2UZ-FE) - System And CIRUIT Testing, On-Vehicle Inspection, Removal, Inspection And Installation: ECM: Removal

1. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL 
   CAUTION: Wait at least 90 seconds after disconnecting the cable from the negative (-) battery terminal to prevent airbag and seat belt pretensioner activation.
2. REMOVE GLOVE BOX COMPARTMENT DOOR 
   1. Remove the 2 screws and glove compartment door.
   Fig 1: Identifying Screws And Glove Compartment Door

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
3. REMOVE NO. 2 FINISH PANEL LOWER 
   1. Remove the 3 screws and No. 2 finish panel lower.
   Fig 2: Identifying Finish Panel Lower

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
4. REMOVE ECM ASSEMBLY 
   1. Disconnect the 5 ECM connectors.
   2. Remove the 3 screws and ECM.

Fig 3: Identifying ECM Assembly

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002