Inspection Procedure
- INSPECT AUDIO REAR A/C CONTROL SWITCH (+B, ACC, GND)
- Disconnect the audio and rear A/C control switch A35.
- Measure the resistance according to the value (s) in the table below.
Standard:
TESTER CONNECTION SPECIFIED CONDITION CHARTTester connection condition Specified condition GND - Body ground Always Below 1 Ω - Measure the voltage according to the value (s) in the table below.
Standard:
TESTER CONNECTION SPECIFIED CONDITION CHARTTester Connector Condition Specified Condition +B - GND Always 10 to 14 V ACC - GND Ignition SW ACC 10 to 14 V NG: REPAIR OR REPLACE HARNESS OR CONNECTOR
OK: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN DIAGNOSTIC TROUBLE CODE CHART