Hand-held tester:
- Connect hand-held tester, and check STA signal.
PREPARATION:
- Connect the hand-held tester to the DLC3.
- Turn the ignition switch ON and push the hand-held tester main switch ON.
- Enter the following menus: DIAGNOSIS/ENHANCED OBD II/DATA LIST/ALL/STARTER SIG.
CHECK:
Read the STA signal on the hand-held tester while the starter is operating.
OK:
DATA LISTIgnition Switch Position ON START STA Signal OFF ON OK: Go to step 5 .
NG: Go to next step.
- Check park/neutral position switch (See DTC P0705: TRANSMISSION RANGE SENSOR CIRCUIT MALFUNCTION (PRNDL INPUT)
).
NG: Replace park/neutral position switch. Go to next step 3 after the replacement.
OK: Go to next step.
- Check ignition switch (See INSPECTION
).
NG: Replace ignition switch. Go to next step 5 after the replacement.
OK: Go to next step.
- Connect hand-held tester, and check STA signal.
PREPARATION:
- Connect the hand-held tester to the DLC3.
- Turn the ignition switch ON and push the hand-held tester main switch ON.
- Enter the following menus: DIAGNOSIS/ENHANCED OBD II/DATA LIST/ALL/STARTER SIG.
CHECK:
Read the STA signal on the hand-held tester while the starter is operating.
OK:
DATA LISTIgnition Switch Position ON START STA Signal OFF ON NG: Repair or replace harness and connector.
OK: Go to next step.
- Check DTC reoccur.
PREPARATION:
- Connect the hand-held tester to the DLC3.
- Turn the ignition switch ON and push the hand-held tester main switch ON.
- Clear DTC (see
PRE-CHECK )
Enter the following menus: DIAGNOSIS/ENHANCED OBD II/DTC INFO/CLEAR CODE and press YES.
- Drive the vehicle more than 25 mph (40 km/h) for 20 seconds or more.
CHECK:
Check DTC reoccur.
RESULT:
RESULTDisplay (DTC Output) Proceed to P0617 A No DTC output B A: Replace ECM (See ENGINE CONTROL MODULE (ECM) ).
B: Check for intermittent problems (See PRE-CHECK ).