Inspection Procedure

HINT:

In case of using the hand-held tester, start the inspection from step 1 and incase of not using the hand-held tester, start from step  2.

1. Check brake fluid level warning switch using hand-held tester. 

   PREPARATION: 

   Connect the hand-held tester to the DLC 3.

   CHECK: 

   Check the brake fluid level warning switch using DATA LIST.

   REFERENCE
   
   

   Brake fluid level	Switch
   Normal	OFF
   Abnormal	ON

   1. OK: Proceed to next circuit inspection shown on problem symptoms table (See  PROBLEM SYMPTOMS TABLE  ). 
   2. NG: Go to next step. 
2. Check brake fluid level warning switch. (See  INSPECTION  ). 
   1. NG: Replace the brake fluid level warning switch. 
   2. OK: Go to next step. 
3. Check wire harness and connector between brake fluid level warning switch and body ECU No. 2. 
   1. NG: Repair or replace wire harness or connector. 
   2. OK: Proceed to next circuit inspection shown on problem symptoms table. (See  PROBLEM SYMPTOMS TABLE  ).