Inspection Procedure
WARNING: This page is about a different car, the 2003 Lexus LX 470. However, it is still accessible from the selected car via links, so may be relevant.
- Recheck. (The vehicle when position does not rotating, turn the ignition switch to ON from OFF again.)
- OK : Normal. (While the vehicle position was turning, the ignition switch was turned ON.)
- NG : Go To Next Step
- System check mode. (Is "58-10" is displayed in the unit check mode of the navigation ECU?)
- Yes : Replace the navigation ECU.
- No : Go To Next Step
- System check mode. (Is "58-43" is displayed in the unit check mode of the navigation ECU?)
- Yes : Replace and repair SPD terminal wire harness.
- No : Go To Next Step
- Navigation check mode (vehicle signal check mode: SPD and gyro).
- OK : Replace the navigation ECU.
- NG : Replace or repair wire harness.