Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Lexus >> 2004 >> RX 330 AWD >> Repair and Diagnosis >> External Pages >> Different car >> Section 601 (Engine Control System - System And Circuit Testing, On-Vehicle Inspection, Removal, Inspection & Installation) >> Engine Coolant Temperature Sensor >> Installation

Engine Coolant Temperature Sensor: Installation

WARNING: This page is about a different car, the 2008 Lexus RX 350. However, it is still accessible from the selected car via links, so may be relevant.
  1. INSTALL ENGINE COOLANT TEMPERATURE SENSOR 
    1. Install the engine coolant temperature sensor.

      Torque: 20 N*m (204 kgf*cm, 15 ft.*lbf) 

    2. Connect the engine coolant temperature sensor connector.
      3. Fig 1: Locating Engine Coolant Temperature Sensor Connector
      G04973881Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
  2. INSTALL AIR CLEANER CASE SUB-ASSEMBLY  (See INSTALLATION )
  3. INSTALL AIR CLEANER CAP SUB-ASSEMBLY (See  INSTALLATION   ) 
  4. INSTALL NO. 1 AIR CLEANER INLET  (See INSTALLATION )
  5. INSTALL NO. 2 AIR CLEANER INLET  (See INSTALLATION )
  6. ADD ENGINE COOLANT  (See )
  7. INSPECT FOR COOLANT LEAK  (See ON-VEHICLE INSPECTION )
  8. INSTALL V-BANK COVER SUB-ASSEMBLY 
scientia non olet · About Mike's Workshop Manuals