Inspection Procedure

1. Check for foreign matter around the switch that might prevent operation.

   OK: No foreign matter is found. 

NG: REMOVE ANY FOREIGN MATTER FOUND 

OK: Go to next step. 

1. Enter the "Display Check" mode (Panel Switch Check Mode) (see DISPLAY CHECK MODE (PANEL SWITCH CHECK) ).
   Fig 1: Identifying Multi-Display - Panel Switch Check Mode

   Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002
2. Operate the abnormal switch and check if the switch name and status are correctly displayed.

   OK: The switch name and status are correctly displayed as operated. 

OK: 

REPLACE MULTI-DISPLAY (SEE  REPLACEMENT  ) 

NG: PROCEED TO NEXT CIRCUIT INSPECTION SHOWN IN PROBLEM SYMPTOMS TABLE (SEE  PROBLEM SYMPTOMS TABLE  )