Hand-held tester:

PREPARATION: 

1. Connect the hand-held tester to the DLC3.
2. Turn the ignition switch ON and push the hand-held tester main switch ON.
3. Enter the following menus: DIAGNOSIS / ENHANCED OBD II / DATA LIST / ALL / STARTER SIG.

CHECK: 

Read the STA signal on the hand-held tester while the starter is operating.

OK: 

Fig 1: Ignition Switch Position Chart

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. OK: Go to step   5 . 
2. NG: Go to next step. 

1. NG: Replace park/neutral position switch. Go to next step 3 after the replacement. 
2. OK: Go to next step. 

1. NG: Replace ignition switch. Go to step   5  after the replacement. 
2. OK: Go to next step. 

PREPARATION: 

1. Connect the hand-held to the DLC3.
2. Turn the ignition switch On and push the hand-held tester main switch ON.
3. Enter the following menus: DIAGNOSIS / ENHANCED OBD II / DATA LIST / ALL / STARTER SIG.

CHECK: 

Read the STA signal on the hand-held tester while the starter is operating.

OK: 

Fig 2: Ignition Switch Position Chart

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. NG: Repair or replace harness and connector. 
2. OK: Go to next step. 

PREPARATION: 

1. Connect the hand-held tester to the DLC3.
2. Turn the ignition switch ON and push the hand-held tester main switch ON.
3. Clear DTC (See PRE-CHECK )

   Enter the following menus: DIAGNOSIS/ENHANCED OBD II /DTC INFO/ CLEAR CODE and press YES

4. Drive the vehicle more than 40 km/h (25mph) for 20 seconds or more.

CHECK: 

Check DTC reoccur.

RESULT: 

Fig 3: Display (DTC Output) Chart

Courtesy of © TOYOTA, LICENSE AGREEMENT TMS1002

1. A: Replace ECM (See  HOW TO USE THE DIAGNOSTIC CHART AND INSPECTION PROCEDURE  ). 
2. B: Go to next step. 

   Check for intermittent problems (See  PRE-CHECK   .