Circuit Description
The IAT sensor is a thermistor built into the MAF sensor and is used to monitor temperature of air flowing through MAF sensor. DTC is set when ECM detects an open or short IAT circuit. ECM will operate in fail-safe mode if DTC P0110 is set. Possible causes are:
- IAT sensor open or short circuit.
- IAT sensor.
- ECM.
NOTE:
If DTCs P0110, P0115, P0120, P0450 and P1120 are output together, inspect ECM terminal E2 (ground) circuit. Repair as necessary. See appropriate wiring diagram in WIRING DIAGRAMS
article.