Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Lexus >> 1997 >> SC 400 >> Repair and Diagnosis >> External Pages >> Different car >> Section 1 (Engine Controls - Tests W/Codes) >> Circuit Tests >> DTC P0402 - Excessive EGR Flow Detected >> Test Drive Confirmation

Test Drive Confirmation

WARNING: This page is about a different car, the 1997 Lexus SC 300. However, it is still accessible from the selected car via links, so may be relevant.
  1. Connect scan tool to Data Link Connector (DLC) No. 3. See Figure. Start and warm engine to normal operating temperature. Operate vehicle at 43-56 MPH for 3 minutes or more. Stop vehicle, and allow it to idle for about 2 minutes. Turn ignition off.
  2. Start engine and allow it to idle. Operate vehicle at 43-56 MPH for 3 minutes or more. Stop vehicle and allow it to idle for about 2 minutes.
  3. Check READINESS TESTS mode on scan tool. If COMPL is displayed on scan tool and MIL is not illuminated, system is normal. If INCPL is displayed and MIL is not illuminated, repeat test drive procedure.
scientia non olet · About Mike's Workshop Manuals