Safety Recall: Dynamic Stability Control Functionality (P062NAS1)

Publication date: 2015-04-14
Reference number: P062NAS1

SAFETY RECALL: DYNAMIC STABILITY CONTROL FUNCTIONALITY

SERVICE CAMPAIGN BULLETIN

Reference Number(s): P062NAS1, Date of Issue: April 14, 2015

LAND ROVER:	2015 LR4 (LA)
SECTION:	206-09
AFFECTED VEHICLES:	LR4 (LA) Model Year: 2015 VIN: FA736361-FA761383

CONDITION SUMMARY

Situation: A concern has been identified with the software within the Anti-lock Brake System (ABS) which was introduced at 2015 Model Year to support the introduction of a new Integrated Monitoring Unit on Land Rover LR4 vehicles.

Action: Jaguar Land Rover Limited has taken the decision to recall affected vehicles to download the latest level of software.

Retailers are required to HOLD only affected new vehicles that are within your control and refrain from releasing the vehicles for new or used vehicle sale pending completion of the rework action detailed in this Technical Bulletin. Unsold vehicles should have this performed as part of the Pre-Delivery Inspection (PDI) process but must have it completed prior to vehicle handover to the customer.

Affected vehicles already in the hands of customers should be updated at the next available opportunity.

PARTS

No Parts Required

SPECIAL TOOLS

NOTE: This document is an 'Active Bulletin' that will display a functional programming shortcut if accessed within a diagnostic session using SDD.

SDD with latest SDD-DVD and Calibration File; first available on DVD141.05 and Calibration File 205

Jaguar Land Rover-approved Midtronics Battery Power Supply

WARRANTY

NOTE: Check DDW to ensure that the vehicle is affected by this program prior to undertaking any rework action. Repair procedures are under constant review, and therefore times / prices are subject to change; those quoted here must be taken as guidance only. Refer to the Repair Times Searcher (RTS) on TOPIx to obtain the latest repair time. At the time of confirming a booking for vehicle repair, ensure that all outstanding Service Actions are identified to ensure the correct parts are available and adequate workshop time is allocated for repairs to be completed at one visit.

Warranty claims must be submitted quoting Program Code 'P062' together with the relevant Option Code from the table. The SRO and part information listed have been included for information only. The Option Code(s) that allows for the drive in/drive out allowance can only be claimed if the vehicle is brought into the workshop for this action alone to be undertaken.

Program Code	Option	Description	SRO	Time
P062	B	Configure ABS control module	70.90.03	0.3
P062	C	Configure ABS control module Drive in/drive out	70.90.03 02.02.02	0.3 0.2

NOTE: Normal Warranty policies and procedures apply

SERVICE INSTRUCTION

CAUTION: A Jaguar Land Rover-approved Midtronics battery power supply must be connected to the vehicle battery during SDD diagnosis / module programming.

CAUTION: Ensure all ignition 'ON' / ignition 'OFF' requests are carried out; failure to perform these steps may cause damage to control modules in the vehicle.

NOTE: SDD must be loaded with DVD141.05 and Calibration File 205.

Connect SDD to the vehicle and begin a new diagnostic session, SDD will read the correct VIN for the current vehicle.
Follow the SDD prompts.
If the hyperlink is not available, the application can be found as follows:
Select 'Diagnosis' session type.

Select the following symptoms: Electrical-instruments-warning lamp-ABS lamp-Lamp illuminated.

Select the 'Extras' tab.

Run 'Configure existing module - ABS control module'.
Follow all on-screen instructions to complete this task. When the task is completed, exit the current session.
Disconnect SDD and the battery support unit/power supply.