Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Land Rover >> 2013 >> LR4 Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 89 (Anti-Lock Control - Traction Control -- LR4/L319) >> Anti-Lock Control - Traction Control >> Rear Wheel Speed Sensor >> Removal And Installation >> Removal

Removal And Installation: Removal

WARNING: This page is about a different car, the 2016 Land Rover LR4, 2015 Land Rover LR4, and 2014 Land Rover LR4. However, it is still accessible from the selected car via links, so may be relevant.
  1. WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.

    Raise and support the vehicle.

  2. Remove the wheel and tire.
  3. G11597371

    Disconnect the anti-lock brake system (ABS) sensor electrical connector.

    • Release the wiring harness retaining clip.
  4. G11597372

    Release the wheel speed sensor from the wheel knuckle.

    • Release the wiring harness.
    • Remove the retaining bolt.
  5. G11597373

    Remove the wheel speed sensor.

    • Release the wiring harness from the 4 clips.
scientia non olet · About Mike's Workshop Manuals