Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Land Rover >> 2012 >> Range Rover Autobiography >> Repair and Diagnosis >> External Pages >> Different car >> Section 7 (Ride And Handling Optimization) >> Ride And Handling Optimization >> Removal And Installation >> Valve Block Transducer >> Installation

Valve Block Transducer: Installation

WARNING: This page is about a different car, the 2010 Land Rover Range Rover Sport. However, it is still accessible from the selected car via links, so may be relevant.
  1. Install the valve block transducer.
    • Clean the component mating faces.
    • Tighten to 25 Nm (18 lb.ft).
    • Remove the container.
  2. Start the engine and allow to idle.
  3. Check and top-up the Dynamic Response system fluid reservoir.
scientia non olet · About Mike's Workshop Manuals