Pressure Control Valve: Installation
WARNING: This page is about a different car, the 2010 Land Rover Range Rover Sport. However, it is still accessible from the selected car via links, so may be relevant.
- Install the PCV valve.
- Clean the component mating faces.
- Install the PCV valve.
- Torque: 35 Nm (26 lb.ft).
- Install the solenoid.
- Install the O-ring seal.
- Tighten to 12 Nm.
- Install the electrical connector.
- Install the new valve block filter.
- Clean the component mating faces.
- Install a new access plug O-ring seal.
- Tighten the access plug to 62 Nm (46 lb.ft).
- Remove the container.
- Remove the hose clamps.
- Secure the valve block to rear stabilizer bar actuator pipe assembly mountings.
- Tighten the nut to 9 Nm (7 lb.ft)
- Check and top-up the dynamic response system fluid reservoir.
- Start the engine and allow to idle.
- Check and top-up the dynamic response system fluid reservoir.
- Make sure there is fluid circulation through the reservoir.