Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Land Rover >> 2012 >> Range Rover Autobiography >> Repair and Diagnosis >> External Pages >> Different car >> Section 7 (Ride And Handling Optimization) >> Ride And Handling Optimization >> Removal And Installation >> Direction Control Valve Solenoid >> Installation

Direction Control Valve Solenoid: Installation

WARNING: This page is about a different car, the 2010 Land Rover Range Rover Sport. However, it is still accessible from the selected car via links, so may be relevant.
GJ0014369
  1. Install the solenoid.
    • Install the O-ring seal.
    • Tighten to 12 Nm.
  2. Install the valve block. See Valve Block .
  3. Bleed the dynamic response system. See Active Stabilization System Bleeding .
scientia non olet · About Mike's Workshop Manuals