Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Land Rover >> 2012 >> LR4 Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 1 (Ride And Handling Optimization) >> Ride And Handling Optimization >> Removal And Installation >> Rear Stabilizer Bar Bushing >> Installation

Rear Stabilizer Bar Bushing: Installation

WARNING: This page is about a different car, the 2012 Land Rover Range Rover Sport and 2011 Land Rover Range Rover Sport. However, it is still accessible from the selected car via links, so may be relevant.
CAUTION: The bush must be installed without any additional lubricant. Failure to follow this instruction may cause damage to the component.
  1. Install the stabilizer bar bushings.
  2. Install the stabilizer bar clamps.
    • Tighten the 4 retaining bolts to 62 Nm (46 lb.ft).
  3. Install the body mounts.
  4. Lower the body.
    • Remove the stands.
  5. Install the body mount retaining bolts.
    • Tighten the 8 retaining bolts to 133 Nm (98 lb.ft).
  6. Install the wheels and tires.
  7. Lower the vehicle.
  8. Install the spare wheel and tire.
  9. Install the rear bumper cover. Refer to Rear Bumper Cover - Removal and Installation .
scientia non olet · About Mike's Workshop Manuals