Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Land Rover >> 2012 >> LR2 Base >> Repair and Diagnosis >> External Pages >> Different car >> Section 392 (Climate Control System - General Information -- XF/X250) >> Climate Control System - General Information >> Specifications >> Refrigerant Oil Adding Capacities

Refrigerant Oil Adding Capacities

WARNING: This page does not describe the selected car, but rather 6 other vehicles, including the 2015 Jaguar XFR, 2015 Jaguar XF, 2014 Jaguar XFR, 2014 Jaguar XF, and 2013 Jaguar XFR. However, it is still accessible from the selected car via links, so may be relevant.
NOTE: Rotate the A/C compressor shaft at least 6 to 8 turns when draining the refrigerant oil.
ITEM MILLILITERS
A/C condenser core and desiccant bag Add 25ml oil
A/C evaporator Add 30ml oil
A/C compressor
  1. Drain old A/C compressor. With drain plug removed and ports uncapped, rotate shaft to remove A/C compressor oil and measure the amount of oil captured.
  2. Drain new A/C compressor into a clean vessel. With drain plug removed and ports uncapped, rotate shaft to remove oil. Then add back a quantity of the new oil that is identical to the quantity of oil removed from the old A/C compressor. However, if this quantity is less than 30ml, then make it up to 30ml.
A/C lines - if air conditioning has been operational. Add 5ml oil per A/C line
A/C system after flushing - with new compressor installed No oil should be used-new oil in new compressor is sufficient
A/C system after flushing - without a new compressor installed - remaining A/C compressor oil is to be drained. Compressor and expansion valve must not be flushed (removed from the circuit) Add 80ml oil
scientia non olet · About Mike's Workshop Manuals