New Workshop Procedure - Remove / Install The Active On-Demand Coupling Module (LTB00161)
Publication date: 2008-10-07Reference number: LTB00161
NEW WORKSHOP PROCEDURE - REMOVE / INSTALL THE ACTIVE ON-DEMAND COUPLING MODULE
TECHNICAL SERVICE BULLETIN
Reference Number(s): LTB00161, Date of Issue:
07 OCT 2008
| LAND ROVER: | 2008 LR2 - Onwards (LF) |
| Issue: | : 1 |
| SECTION: | : 205 |
| AFFECTED VEHICLE RANGE:: | VIN: 8H000212 - Onwards |
CONDITION SUMMARY
Situation: The procedure to remove / install the Active On-Demand Coupling Module has been revised. It is no longer necessary to drain and refill the oil within the unit.
Action: In the event it becomes necessary to remove / install the Active On-Demand Coupling Module, refer to the Repair Procedure outlined below.
PARTS
No parts necessary; information only
TOOLS
Refer to Workshop Manual (GTR) for any required special tools
WARRANTY
NOTE:
Repair procedures are under constant review, and therefore times are subject to change; those quoted here must be taken as guidance only. Always refer to DDW to obtain the latest repair time.
DDW requires the use of causal part numbers. Labor only claims must show the causal part number with a quantity of zero.
WARRANTY CHART
| Description | SRO | Old Time (Hours) | New Time (hours) |
|---|---|---|---|
| New - Module - Active On-Demand Coupling - Renew | 51.30.03 | 0.50 | 0.20 |
| New - Sensor - Temperature and Pressure - Active On-Demand Coupling - Renew | 51.30.04 | 0.50 | 0.20 |
| New - Throttle valve - Active On-Demand Coupling - Renew | 51.30.05 | 0.50 | 0.20 |
Normal warranty policy and procedures apply.
REPAIR PROCEDURE
REPLACE ACTIVE ON-DEMAND COUPLING MODULE
NOTE:
Global Technical Reference (GTR) lookup sequence is as follows:
GTR Home > NAS > LF-LR2 > Service Information > Model Year > Workshop Manual >
GTR Home > NAS > LF-LR2 > Service Information > Model Year > Workshop Manual >
2: Chassis > 205-02 > Rear Drive Axle / Differential > Active On-Demand Coupling Module (51.30.03)
- Refer to Workshop Manual (GTR) Section 51.30.03 to remove / install the Active On-Demand Coupling Module.
NOTE:
The information in Technical Bulletins is intended for use by trained, professional Technicians with the knowledge, tools, and equipment required to do the job properly and safely. It informs these Technicians of conditions that may occur on some vehicles, or provides information that could assist in proper vehicle service. The procedures should not be performed by 'do-it-yourselfers'. If you are not a Retailer, do not assume that a condition described affects your vehicle. Contact an authorized Land Rover service facility to determine whether this bulletin applies to a specific vehicle.