Electronic Engine Controls (4.2L): Specifications
WARNING: This page is about a different variant/trim than selected.
LUBRICANTS
| Item | Land Rover Part No. |
|---|---|
| * HO2s removal | STC 50545 |
| HO2s threads | Apply suitable high temperature anti-seize compound to threads of sensor |
* Apply to area around sensor threads prior to attempting to remove sensor
ENGINE MANAGEMENT SYSTEM
| Item | Description |
|---|---|
| Engine management system: | |
| Make | Denso |
| Type | PAG EMS - Generation 1 |
TORQUE SPECIFICATIONS
| Description | Nm | lb-ft |
|---|---|---|
| + Heated oxygen sensor (HO2S) | 45 | 33 |
| * RH catalytic converter to exhaust manifold bolts | 22 | 16 |
| * LH catalytic converter to exhaust manifold bolts | 22 | 16 |
| LH catalyst monitor sensor | 45 | 33 |
| Mass Air Flow (MAF) sensor Torx screws | 2 | 1.5 |
| Camshaft position (CMP) sensor bolt | 7 | 5 |
| Crankshaft position (CKP) sensor Torx screw | 7 | 5 |
| Knock sensor (KS) bolt | 20 | 15 |
| Engine oil pressure sensor | 13 | 10 |
| Engine oil temperature sensor | 20 | 15 |
| Manifold Absolute Pressure (MAP) sensor Allen bolt | 3 | 2 |
| Engine harness securing bolts | 10 | 7 |
| Fuel temperature sensor | 7 | 5 |
| Intake Air Temperature sensor Torx screw | 6 | 4 |
| Fuel rail pressure sensor bolts | 6 | 4 |
| Supercharger pressure relief actuator bolt | 10 | 7 |
+ Apply anti-seize lubricant to threads of sensor - Refer to appropriate Lubricant information
* New bolts must be installed