Pinpoint Test R: Vehicle Current Position Mark Turns On Its Own

WARNING: This page is about a different car, the 2006 Land Rover Range Rover. However, it is still accessible from the selected car via links, so may be relevant.

VEHICLES CURRENT POSITION MARK TURNS ON ITS OWN
Determine if the ignition status was turned to Auxiliary or On, while the vehicle was on a turntable in a parking building etc.

Was ignition status set to Auxiliary or On?

YES: The angular speed of the vehicle at the time of the ignition status change will be logged as the standard value. To re-set the standard value, turn ignition status to 'OFF' then to 'Auxiliary' or 'On' with the vehicle stationary. Re-test the vehicle.

NO: Go to step 2.
VEHICLES CURRENT POSITION MARK TURNS ON ITS OWN
Check for logged fault codes in navigation diagnostics.

Is the fault code 58-02 (Gyro system) logged?

YES: Install a new navigation module. module

NO: Go to step 3.
VEHICLES CURRENT POSITION MARK TURNS ON ITS OWN
Check for logged fault codes in navigation diagnostics.

Is the fault code 58-03 (vehicle speed system) logged?

YES: Take measures in accordance with navigation DTC index.

NO: Install a new navigation module. module