Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Land Rover >> 2007 >> Range Rover HSE >> Repair and Diagnosis >> External Pages >> Different car >> Section 128 (Anti-Lock Control - Traction Control) >> Anti-Lock Control - Traction Control >> Removal And Installation >> Rear Wheel Speed Sensor >> Removal

Rear Wheel Speed Sensor: Removal

WARNING: This page is about a different car, the 2006 Land Rover Range Rover Sport. However, it is still accessible from the selected car via links, so may be relevant.
    WARNING: Do not work on or under a vehicle supported only by a jack. Always support the vehicle on safety stands.
  1. Raise and support the vehicle.
  2. Remove the wheel and tire.
  3. Disconnect the anti-lock brake system (ABS) sensor electrical connector.
    • Release the wiring harness retaining clip.
    GJ0014570
  4. Release the wheel speed sensor from the wheel knuckle.
    • Release the wiring harness.
    • Remove the retaining bolt.
    GJ0014571
  5. Remove the wheel speed sensor.
    • Release the wiring harness from the 4 clips.
    GJ0014572
scientia non olet · About Mike's Workshop Manuals