Mike's Workshop Manuals: Service manuals for every vehicle
Home >> Land Rover >> 2007 >> Range Rover HSE >> Repair and Diagnosis (Single Page) >> Transmission >> Automatic Trans >> Automatic Transmission/Transaxle (4.4L) >> Automatic Transmission/Transaxle (4.4L) >> In-Vehicle Repair >> Transmission Control Module (TCM) >> Installation

Transmission Control Module (TCM): Installation

    CAUTION: Make sure that when fully fitted, all seals protrude by the same amount.
    CAUTION: Engage the selector lever with the groove in the piston rod.
  1. Install the main control valve body.
    • Clean the component mating faces.
    • Install new seals.
    • Install a new seal block.
    • Tighten the Torx screws to 8 Nm (6 lb.ft).
    GJ0009453
  2. Install a new electrical connector sleeve.
    • Secure with retainer.
  3. Connect the electrical connector.
  4. Install the fluid pan. Refer to Fluid Pan, Gasket and Filter .
  5. Connect the battery ground cable. Refer to Specifications .
  6. Calibrate a new main control valve body using T4.
scientia non olet · About Mike's Workshop Manuals